Checking Fixture For Rear bumper trim
- FIFM
- CHINA
- 30 working days
- 800 sets/year
Gauge type: Checking Fixture For Rear bumper trim
Inspection type: check the trim edge of part
Checking Fixture For Rear bumper trim
操作步骤 Operation Steps:
1.将所有卡扣调节至非工作状态;
1.Open the clips
2.闭合卡扣,将产品对准基准B/C套入检具上。确保产品与基准面A1-A7贴零,将产品轻拍入检具,拧紧A5~A7对应的压紧销。产品完全定位;
2.Close clips, put the part on the gauge against datum B/C, make sure part contact the datum faceA1-A7 completely, tighten the screw pins, part located
3.切边轮廓检测:用GO2.5/NOGO3.5通止规检测产品全周切边轮廓,通端能能通过,止端不能通过,产品合格;反之则不合格。
3.Trim edge check: use GO2.5/NOGO3.5 to check trim edge round.
4.打开卡扣,将所有零件归位,取出产品,完成本次检测。
4.Open the clips, take off part, inspection finished.
Mainly check the gap between the rear bumper trim and surrounding parts.